1959 MORRIS MINI FLECK FRONT SEAT KIT Saloon 1973 on When we designed our very

When we designed our very popular Suffolk front seats

The panels are made using our frequency welding machine and we believe are the most common design used on Australian trim

The main flat piece has a slit half way up which will allow a calico flap from the seat cover to be pulled through to be attached to the frame

Newton Commercial Part No - 823311

Please note these are only suitable for seats that used the separate raised side bolster design and not seats that were made with a single moulded flatter base foam

1959 MORRIS MINI FLECK FRONT SEAT KIT Saloon 1973 on When we designed our veryIn the early years of production manufacture was shared between two factories. While mechanically the same, the Austin Seven and Morris Mini used their own trim designs and these designs varied throughout these years until trim became more standardised after 1962. This design was used exclusively in early Morris production, and fits the post leg front seat frames (as pictured below). We believe that this trim was only used up until the middle of